Two-component, hyperfluid, epoxy, low-viscosity system for the structural consolidation of cracked concrete structures.
Kerabuild® Epofill is compliant with the performance requirements of the standard EN 1504-5 for injection products.
ΧΑΡΑΚΤΗΡΙΣΤΙΚΑ :
• Low viscosity and excellent injection power
• Rapid hardening
• ideal for grouting of reinforcing rods in horizontal concrete structures
ΧΡΗΣΕΙΣ:
Monolithic repair of cracked concrete elements, grouting of reinforcement rods in cement-based conglomerate structures, repair of
peeling facade elements...
ΠΡΟΕΤΟΙΜΑΣΙΑ
Kerabuild® Epofill is prepared by mixing component a with component b (preset ratio 2:1 in the bags) until a fluid mixture of uniform
colour is obtained. Mix by hand or using a low-rev, mechanical stirring device.
Workability times may vary according to the density of the mixed paste and the temperature of the environment and substrate: the higher the temperature or the larger the mixture, the lower the time.
ΕΦΑΡΜΟΓΗ:
When grouting steel rods in holes made in concrete elements, remove any residual dust using a jet of compressed air, then apply
Kerabuild® Epofill by pouring to strengthen cracked structures by first opening the crack using a flexible joint, removing any dust then injecting Kerabuild® Epofill under pressure into previously drilled injection holes. subsequently, the crack can be filled with Kerabuild® Eco Epobond through injection tubes inserted into the same holes as before. once Kerabuild® Eco Epobond has hardened, blow compressed air into the system to check that the holes are in communication. subsequently, inject Kerabuild® Epofill using specific tools, starting from the lowest injection tube; when the resin comes out of the topmost tube, seal the one used for injection and repeat the procedure again starting from the control injection tube, until the crack is completely sealed.
ΚΑΘΑΡΙΣΜΟΣ
Residual traces of Kerabuild® Epofill can be removed from tools with solvents (ethyl alcohol, toluol, xylene)